View Full Version : Bearing replacement
zims23
02-24-2015, 07:21 PM
I am looking for a place in the edmonton area that can replace a couple bearings for me. The wheel bearings look pressed in. These are from an old utility trailer. Any suggestions? I would prefer a place that has the bearings and can do the removal and installation.
lake side
02-24-2015, 07:27 PM
PM incoming.....
L.S
omega50
02-24-2015, 07:31 PM
Hammer-socket-grease
deerhunter
02-24-2015, 08:51 PM
Heat it up punch it out
Kim473
02-25-2015, 05:29 AM
No heat, just press it out using a good vise or hammer it out. Remove c-clips if any and go to it. Carefull when putting the new one in so as to not damage it.
vBulletin® v3.8.5, Copyright ©2000-2024, Jelsoft Enterprises Ltd.