Rock Doctor
03-20-2021, 06:24 PM
We are getting one of our Conquests ready for spring and had a few outer axle bearings to change out. The front left axle was being a real pain, resisting all my removal tricks. The inner axle bearing simply would not let the axle go. Set screws out, penetrating oils applied, I tried hammering, tapping, cussing and swearing.
My helpers and I decided to make an “Axle removal tool”, I’m sure there are many different versions, but this is what we came up with for removing stubborn front axles with random stuff in the shop.
We tested the fit on a rear axle, then slid the tool under the engine and tried the front axle.
WINNER, it worked beautifully 👍
https://i.imgur.com/KmDlZHR.jpg
https://i.imgur.com/54M4afT.jpg
https://i.imgur.com/UBTIOzZ.jpg
https://i.imgur.com/Vf7ezNB.jpg
https://i.imgur.com/3FaTPcA.jpg
https://i.imgur.com/QllLqpe.jpg
https://i.imgur.com/xHzewME.jpg
https://i.imgur.com/fwSOVbf.jpg
RD
My helpers and I decided to make an “Axle removal tool”, I’m sure there are many different versions, but this is what we came up with for removing stubborn front axles with random stuff in the shop.
We tested the fit on a rear axle, then slid the tool under the engine and tried the front axle.
WINNER, it worked beautifully 👍
https://i.imgur.com/KmDlZHR.jpg
https://i.imgur.com/54M4afT.jpg
https://i.imgur.com/UBTIOzZ.jpg
https://i.imgur.com/Vf7ezNB.jpg
https://i.imgur.com/3FaTPcA.jpg
https://i.imgur.com/QllLqpe.jpg
https://i.imgur.com/xHzewME.jpg
https://i.imgur.com/fwSOVbf.jpg
RD