I disageree. It shoots great and the only issue is the neck juncture is a hair short. I would neever send it back for that. I would figure out the neck length and keep my brass at that Iength. Saves carbon rings too. Even by SAAMI specs there is a ..01 tolerance, check the drawing. This is very far from being an issue that needs fixing once you understand where it is at. I have seen many great shooting chambers that were way further out dimension wise than this. That is more than half the point of reloading. Fitting loads to the exact dimensions of the gun you have. That is precisely what makes them so much more accurate than SAAMI loaded factory ammo.
|