Quote:
Originally Posted by Bonescreek
brendon's dad, how's the arrow cut off working for you ?
I'm working on building one with a grinder that travels into the cut with an
adjustable stop (I'll set to 1/8" deep cut). To bring the grinder into the
arrow instead of swinging the arrow into the cut off wheel.
Don't want to derail this thread so I'll start a new post on the cut off saw
build.
|
Works good. Just make sure once the arrow is set in the door latch base in a position which is perfectly square with the 2 L brackets. And then make sure this alignment places the arrow shaft in such a position that the cut off wheel is only cutting through 1 wall of the arrow at a time. This will keep your cut as square as possible. I then coat the cut end with a gold sharpie and use an arrow squaring device until all the sharpie is gone.