[graybeard]

Good morning everyone:
I recently picked up a 1960's vintage; Browning Auto-5, from an old friend. I want to refinish the wood.
I have been on the Steve's Pages and there is not enough information as well viewed several You Tube videos.....no luck yet!

Questions:
1/ how do I remove the stock (the fore end was a cinch)? There is no long screw inside, like the 870. There are however, several screws that appear to enter the stock from just behind the trigger tang; and one through the receiver.

2/ the screws have such a narrow slot in them that a conventional screw driver will not fit nor will the ones I have with my Wheeler torque set.
Where do I find the proper screw drivers to do the job properly?

Thanks for your time.