Quote:
Originally Posted by JBE
Really only because I have been using adg and my loads are developed. I tried some lapua but it will require more tinkering. I use accubonds and have a supply but can burn them up pretty fast to get the lapua to where I am now with adg.
|
I think I first developed my current load with nosler brass, and started using ADG when that came in. I haven't adjusted my load for the ADG brass.
That said, I was not printing the same tight groups at 100 on the weekend as previously, but was having no problems out to 1000m. Go figure.
I'm currently awaiting the weekend, and hoping for a quiet windless sat morning as I have some loaded using a mandrel die. 10 rounds with mandrel, 10 rounds without, to see if the groups change at 100m.
I guess then I'll tweek my load using that for the ADG brass. I have 100 more new, and then a few hundred lapua awaiting use, and only using 100 ADG brass for now. Now annealing after every firing, and this is new as well, so alot going on at once.