Quote:
Originally Posted by cschache
OH G'S good eye!! I never even took that into consideration! thinking too far ahead, I just went and measured the auger shaft to outside of handle and its 10.5" and measured from center of the 12" hole to where the walls will be is 11 1/4", the auger I have is an 8" and the catch covers are 12", will definitely have to check once the walls are up incase of adjustments,no doubt its going to be tight but I think it will work out!
|
If it is easier than a total redo of your floor, just convert an 18 volt drill to turn your auger. Kits are cheap. No fumes inside.