|
05-05-2024, 04:11 PM
|
|
|
|
Join Date: Dec 2007
Location: Calgary, AB
Posts: 457
|
|
Seeking Advice on Backyard Retaining Wall and Fence Project to Level Yard
Seeking guidance for a backyard project! We're planning to build a retaining wall and fence to improve privacy, replace our existing fence, and level out the yard for better usability—especially for the little ones and summer BBQs. I've included some photos of the design and the current state of the fence and landscape.
We're thinking the retaining wall should be about 32 inches high along the part of the fence that runs parallel to the sidewalk, tapering off as the fence turns towards the house. It will also taper off gradually to the ground level near the vehicle gate in the alley. We intend to keep the current chain link vehicle gate and man gate beside the garage. The new fence will be built with 6-foot-tall MicroPro Sienna treated lumber, and the retaining wall may use 4 x 6 pressure-treated lumber stacked horizontally.
We'll level the yard to match the grade at the man gate by the house, making the area more functional. Any advice on the project, including tips or alternative construction methods, would be greatly appreciated. We're planning on using MicroPro Sienna treated lumber, gravel backfill, and weeping tile for optimal drainage. If anyone has resources or documentation on best practices for this kind of work, please share!
I'm a seasoned DIYer, but this project is a first for me. As a Journeyman Electrician, I'm used to following codes and guidelines, but any extra help specific to this project would be much appreciated. Thanks in advance for your insights!
P.S. I'll definitely need some privacy when I'm butchering game and cleaning skulls—wouldn't want the neighbors thinking I'm auditioning for a horror movie!
This is the style of fence / retaining wall I would like to build, but have the top of the fence all on one level:
The Following images are the existing fence that I would like to replace, except I will plan to keep the existing vehicle gate and man gate in the back alley:
Thanks again for all your help!
Last edited by shootermcgavin; 05-05-2024 at 04:17 PM.
|
05-05-2024, 04:25 PM
|
|
|
|
Join Date: Sep 2008
Location: Edmonton Alberta
Posts: 9,889
|
|
Impressive.
One thing I did with the 4x6" for a retaining wall was to drill thru and use heavy rebar and pound it thru the 4x6's into the ground. Then I just drilled out some plugs from a scrap piece to cap the holes in the 4x6......
There's my big idea.......
__________________
When you are born, you get a ticket to the Freak Show.
If you are born in Canada, you get a front row seat.
|
05-05-2024, 04:27 PM
|
|
|
|
Join Date: Jan 2008
Location: Calgary Perchdance
Posts: 19,285
|
|
Retaining walls are a pain in the ass.
Instead just rent a bobcat and level with a slope away from the house. Ensure great drainage. At the same time put in a sprinkler system.
__________________
Observing the TIGSCJ in the wilds of social media socio-ecological uniformity environments.
|
05-05-2024, 04:42 PM
|
|
|
|
Join Date: Jul 2008
Location: calgary
Posts: 870
|
|
Ahh City of Calgary
Before putting shovels on the ground
https://www.calgary.ca/development/h...ng/fences.html
__________________
“It is not the man who has too little, but the man who craves more, who is poor.”
|
05-05-2024, 06:02 PM
|
|
Moderator
|
|
Join Date: Feb 2015
Posts: 8,000
|
|
I'd just recommend three things...
1. If you're building it in Calgary, make sure you're permits are good to go unless you want to be a rebel and chance it.
2. Have drainage on the earth side of the wall or ensure the wall is permeable.
3. Either build it right, so it's doesn't lean, or have mechanism to straighten it (if it starts to lean, you'll likely need to remove dirt prior to straightening it), like so:
__________________
I hope I don't vote for Biden when I'm dead!
|
05-05-2024, 09:43 PM
|
Moderator
|
|
Join Date: Aug 2012
Location: Wheatland County
Posts: 5,826
|
|
I know a guy that's got a skid-steer that vibrates, think of it as a 2 for 1 machine. For a slight financial consideration, I'll have him reach out to you
__________________
If you're not a Liberal when you're young, you have no heart. If you're not a Conservative when you're old, you have no brain. Winston Churchill
All tyranny needs to gain a foothold is for people of good conscience to remain silent. Edmund Burke
|
05-05-2024, 10:29 PM
|
|
|
|
Join Date: Oct 2011
Location: Westerose
Posts: 4,208
|
|
Quote:
Originally Posted by Trochu
I'd just recommend three things...
1. If you're building it in Calgary, make sure you're permits are good to go unless you want to be a rebel and chance it.
2. Have drainage on the earth side of the wall or ensure the wall is permeable.
3. Either build it right, so it's doesn't lean, or have mechanism to straighten it (if it starts to lean, you'll likely need to remove dirt prior to straightening it), like so:
|
When we bought our place in Calgary, the people we bought from were not impressed with the landscaping that the neighbour had done a few years earlier. They had put a retaining wall up against the fence and leveled (+/-) their yard. The change in elevation was 4 or 5 feet at the highest point. We bought the place and there was no issue for about 20 years until the new neighbours decided they wanted a hot tub. A crew came in with a compactor and started compacting their yard (felt like someone was trying to drive a tractor through our house ). Before they had the hot tub installed, we noticed that their yard was trying to slide into our yard...
Be careful what you do when trying to change grade.
ARG
__________________
In the immortal words of Jean Paul Sartre, 'Au revoir, gopher'.
Quote:
Originally Posted by sjemac
It has been scientifically proven that a 308 round will not leave your property -- they essentially fall dead at the fence line. But a 38 round, when fired from a handgun, will of its own accord leave your property and destroy any small schools nearby.
|
|
05-06-2024, 06:50 AM
|
|
|
Join Date: May 2014
Posts: 911
|
|
You may want to consider keeping some of the grade for water runoff. Could you just put in 6x6 pressure treated post, but put them about 6’ under ground and cement them in. Then do 3or 4 rows of 6x6 in between the posts anchored to the posts with some sort of Simpson hardware, then fence above that. Could even reduce the spacing between posts to 6’ or so to strengthen everything up a bit. Then just put in the weeping tile and some gravel, then haul in some topsoil to build it up.
|
05-06-2024, 06:50 PM
|
|
|
Join Date: May 2007
Posts: 4,070
|
|
First and foremost, no one on here should be doing bar stool engineering unless they want to be putting their beavertail on the blue prints.
I went through a nightmare file in St. Albert where I was acting for the Purchaser. Vendor gave an old RPR and Stat Dec with a strange Compliance Letter that had an exception on the retaining wall.
Seems the neighbour's wall was collapsing, and 2 owners back there was a caveat put on by the City of St. Albert about the retaining wall. Had to fight with Vendor's lawyer, and City of St. Albert engineering back me, which made sense given the Caveat.
I was acting for relatives and all they wanted was this house come he!! or High Water. All the bank wanted was something they could easily sell if there was a foreclosure. I knew that I was going to have to eat the time, or have problems down the road come time to sell
8 hours of my thrown away time and the Vendor's Lawyer backed down. He had to apply to the City, get the necessary permits, etc.
Sometimes removing a retaining wall, re engineering to current code, and rebuilding can cost $50,000.
This could be your "dream", or your Lawyer's nightmare, in the future, if you decided to go it alone without engineering.
Drewski
|
05-06-2024, 10:36 PM
|
|
|
Join Date: Jan 2010
Posts: 570
|
|
Quote:
Originally Posted by igorot
|
I have built a few retaining walls and fences and feel this is a great first step
I f you want free advice PM me, I'll try and help
|
05-06-2024, 11:43 PM
|
|
|
Join Date: Jul 2007
Posts: 1,097
|
|
Follow the steps
A few steps to follow, in the following order:
1) Hire a competent engineering outfit that has a qualified civil engineer, let him look after the design
2) Apply for the permits with the City, this will require a set of stamped plans
3) Make sure you have completed step 1
4) Hire a contractor that is experienced in installing retaining walls per the engineers design
5) Recheck to ensure that you have completed step 1
6) Hire a competent inspector or get the Engineer of Record to inspect the work as it is being installed
7) Retain copies of the engineering drawings along with a Letter of Compliance issued and stamped by the Engineer of Record
Qualified firms (engg and installation) will carry liability insurance.
I'm expecting to get a lesson on overkill by certain AO experts but having been involved in this work for over 3 decades I stand by my input. Having a retaining wall fail is a big deal, even a small one
|
05-07-2024, 05:20 PM
|
|
|
|
Join Date: Jul 2008
Location: calgary
Posts: 870
|
|
Quote:
Originally Posted by big zeke
1) Hire a competent engineering outfit that has a qualified civil engineer, let him look after the design
7) Retain copies of the engineering drawings along with a Letter of Compliance issued and stamped by the Engineer of Record
|
All you need, just make sure all their credentials are up to date.
__________________
“It is not the man who has too little, but the man who craves more, who is poor.”
|
05-09-2024, 11:38 AM
|
|
|
Join Date: Oct 2007
Location: Stony Plain, AB
Posts: 532
|
|
Quote:
Originally Posted by big zeke
A few steps to follow, in the following order:
1) Hire a competent engineering outfit that has a qualified civil engineer, let him look after the design
2) Apply for the permits with the City, this will require a set of stamped plans
3) Make sure you have completed step 1
4) Hire a contractor that is experienced in installing retaining walls per the engineers design
5) Recheck to ensure that you have completed step 1
6) Hire a competent inspector or get the Engineer of Record to inspect the work as it is being installed
7) Retain copies of the engineering drawings along with a Letter of Compliance issued and stamped by the Engineer of Record
Qualified firms (engg and installation) will carry liability insurance.
I'm expecting to get a lesson on overkill by certain AO experts but having been involved in this work for over 3 decades I stand by my input. Having a retaining wall fail is a big deal, even a small one
|
As a happily retired professional engineer, this is the best advice you should get here.
Vic
|
05-09-2024, 01:24 PM
|
|
|
Join Date: Dec 2014
Posts: 357
|
|
Quote:
Originally Posted by big zeke
A few steps to follow, in the following order:
1) Hire a competent engineering outfit that has a qualified civil engineer, let him look after the design
2) Apply for the permits with the City, this will require a set of stamped plans
3) Make sure you have completed step 1
4) Hire a contractor that is experienced in installing retaining walls per the engineers design
5) Recheck to ensure that you have completed step 1
6) Hire a competent inspector or get the Engineer of Record to inspect the work as it is being installed
7) Retain copies of the engineering drawings along with a Letter of Compliance issued and stamped by the Engineer of Record
Qualified firms (engg and installation) will carry liability insurance.
I'm expecting to get a lesson on overkill by certain AO experts but having been involved in this work for over 3 decades I stand by my input. Having a retaining wall fail is a big deal, even a small one
|
This isn't strictly true - the requirement for engineered drawings depends on the height of the wall. You can look at the City of Calgary requirements, but there is usually a maximum height before a structural design is required.
Otherwise anytime someone stacked a few blocks around their garden they would need a permit.
A permit and design is never a bad idea though as it can save you a lot of headache later.
|
05-09-2024, 02:21 PM
|
|
|
|
Join Date: Dec 2009
Posts: 10,412
|
|
My advice is to ask "will it be worth it?"...
__________________
Alberta Fish and Wildlife Outdoor Recreation Policy -
"to identify very rare, scarce or special forms of fish and wildlife outdoor recreation opportunities and to ensure that access to these opportunities continues to be available to all Albertans."
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -6. The time now is 12:54 AM.
|