Any bit of constructive help would be sooooo greatly appreciated !!!
I had a brand new gas heater installed and Friday afternoon it stopped working.... Had a guy come over and look at it and figured out it was the exhaust fan ( I think ) that was seized.. the guy said he could replace it but that I should call the guy that installed it to do it under warranty... ( I had been trying to get ahold of him with no luck) When the guy was looking at my heater he said there were a few things that weren't code - ( this is where I get ****ed ) He says the yellow flex hose isn't code and that I need a shut off valve inside, I show him the shut off valve at the outside connection coming from the ground into the garage (he says that should be inside) and he says that the swings joints are wrong and looks at the swing joints coming from meter and those are wrong too!!!!! ( with my very limited almost non-existent gas knowledge and ability to interpret what I found on the internet the swing joints need to have a minimum of 3 elbows.... ) I finally heard from my installer ( at 1045pm) and he said he'd come fix the fan (warranty) and I asked him about the flex hose and he said its allowed and that the code was changed about 5 years ago.... Now I just want to know whats right and whats wrong so I can get it fixed if needed to pass inspection. I found out that my permit has expired and will need a new one pulled as well.... so I'd like this to pass the first go round.
Hopefully you guys that have a better idea of WTF is going on can chime in .... as I'd like to call my installer on it on Monday when he shows up.....
https://imgur.com/2oWeiJH
https://imgur.com/Qae5IM1
https://imgur.com/ZqYUZm6
https://imgur.com/r2ojb1v
https://imgur.com/z9eIBOf
Garage heater help/ gas filters!!!!!
Threaded Mode
