Just took one on trade and was wondering what everyone uses for powder and bullets in them,Its a Browning X-bolt hunter model topped with a 6x24x40 4200 elite scope.
I have Hodgon h414 ,Varget and Imr4350 which are all powders used for them
And I run cci primers,but do have winchester and federal 210,
Thanks
Pin
120-139, Varget
140^, 4350
U could use the 414 instead of 4350, but it’s low on my personal preference scale cuz it’s very temp sensitive, dirty, and harder to get going in cold temps(mag primers recommended)
Primers are a run what works for ya sort of thing.
H414 works good in my buddies 7 08,most of the stick powders(4350,N165) fill the case and run over the 100% load density in the upper loads.If you can find a noad down low with 4350 you won't be crushing powder.If you use the h414 definatly use a magnum primer.I have had a couple hangfires with it in cooler weather.
7mm-08
Linear Mode
