Owners Manuals are a great tool
https://tactacam.zendesk.com/hc/en-u...20040507720219
SETTING UP THE CAMERA
QUICK START GUIDE
1. Install camera’s antenna.
• Note: Do not over tighten the antenna, once it is secure stop tightening to prevent
antenna port damage.
2. Install a Class 10 U3 SD card (32GB).
• Recommended brands are: SanDisk, Lexar and Tactacam
3. Install 12 AA batteries.
• To eject the battery tray, press the EJECT button on the REVEAL. When inserting
AA batteries correctly orientate + and - on the front and back of the tray.
• See battery details on page 14 under Best Practices.
SIM Card
For cameras with a single SIM, the card may or may not be pre-installed. Cameras
packaged with two SIMs allow you to select a carrier that works strongest in the
area of your camera’s location. NOTE: SIM cards are exclusively paired to a camera
at the time of manufacture, so please do not remove, swap, or replace with a
different SIM card.
Activation of your camera can be done conveniently through the REVEAL mobile
app during setup.
https://www.revealcellcam.com/data-plans
CAMERA STOPS TAKING IMAGES OR WON’T TAKE IMAGES
1. Make sure that the SD card is not full. If the SD card is full, the camera
will stop taking images. Users can turn on SD Loop to avoid such
problems. This will cause the SD card to overwrite older images.
2. Make sure that alkaline or NiMH-AA batteries have enough power for the
camera to work.
3. Format the SD card with the camera before using or when the camera
stops taking images.