Recoil pad installation?

[Pathfinder76]

Does anyone know of someone in the extreme south west corner of the province that can do a good job of installing a grind to fit recoil pad on a finished stock? Thanks.

[Nyksta]

Limbsaver airtech has a whole bunch of different sizes, and they provide dimensions with templates on their website. This might be an option instead if the trouble of the grind to fit style.

[boonedocks]

Sorry, not to hijack your thread, I have the same question but In Edmonton?!

[elkhunter11]

Originally Posted by boonedocks

Sorry, not to hijack your thread, I have the same question but In Edmonton?!

Rod Henrickson did a great job on a rifle for me. He also shortened the stock slightly to maintain the length of pull.

[AlbertaAl]

Rod wont touch a LIMBSAVER brand ,,,something to do with it emitting too much debris during the grinding process.
P&D Ent. will install it for $50. , excellent job

[partsman]

I have always done my own, but use lots of tape to protect the stock juts in case.

[270person]

Originally Posted by boonedocks

Sorry, not to hijack your thread, I have the same question but In Edmonton?!

Sights and Arms St Albert did a very nice cut and grind for me. IMO Pachmayr grind to fit the only way to go.

[fps plus]

Limbsaver and kickeez pads do not finish up as nice as pachmyr. As well Sometimes the edges of the rubber chip out as well

[WinefredCommander]

Originally Posted by chuck

Does anyone know of someone in the extreme south west corner of the province that can do a good job of installing a grind to fit recoil pad on a finished stock? Thanks.

If you have any luck. I'm also looking for someone to do a recoil pad on a 1950's superposed 20g.

[NCC]

Hillbilly Arms in Nanton has installed a couple of recoil pads for me and I’m happy with the results.