O.K. wf's new rifle is on the dot! We would like to move the disks on the turret to a zero point. I can't see any zero mark. Is there a generally accepted way to do this. I'm about to nick the rim with a hack saw, but I'll await the advice.
Thanks.
__________________
"The well meaning have done more damage than all the criminals in the world" Great grand father "Never impute planning where incompetence will predict the phenomenon equally well" Father
It is a weaver. You can loosen the 2 screws on the disk and rotate the disk without changing the cross hairs. The problem I have is if I move them when I change ammo or "zero" how do I get them back to the same spot? Does that make sense? There is no mark on the turret rim.
__________________
"The well meaning have done more damage than all the criminals in the world" Great grand father "Never impute planning where incompetence will predict the phenomenon equally well" Father
It is a weaver. You can loosen the 2 screws on the disk and rotate the disk without changing the cross hairs. The problem I have is if I move them when I change ammo or "zero" how do I get them back to the same spot? Does that make sense? There is no mark on the turret rim.
One does wonder however why doesn't the manufacturer put a "small mark" on the rim.
I've got a small hack saw that will do the trick.
__________________
"The well meaning have done more damage than all the criminals in the world" Great grand father "Never impute planning where incompetence will predict the phenomenon equally well" Father
Zero mark on scope turret?
Thanks lefty
Linear Mode
