Go Back   Alberta Outdoorsmen Forum > Main Category > Guns & Ammo Discussion

Reply
 
Thread Tools Display Modes
  #1  
Old 11-18-2015, 07:16 PM
Bganz Bganz is offline
 
Join Date: Sep 2014
Posts: 121
Question Surface rust on new rifle

Hey Everyone!

So I bought my first rifle, a new stainless steel Tikka T3 Lite 30-06 (and I love it!). I purchased the rifle over the phone and picked it up in the box and brought it home. But, when I got it home and took it out I noticed some surface rust.

I switched the recoil pad to a limb saver and the screws were covered in rust and what looked to be some sort or white build up. I sprayed the screws down with G96 and scrubbed them with a brass brush and that seemed to help quite a bit. Then I tried to clean where screws go in with G96 and patches. The barrel doesn't seem to have any rust spots on it, but there are small spots over the action and on the bottom where it is sits in the stock. I've just been soaking it in G96 and wiping it off with rags and it seems to be helping and has removed some spots, but it appears I've reached the max that will remove and there are still some stubborn ones. It's not crazy bad, but I just want to baby this rifle as I need it to last me a long time.

Anyways, I'm new to the sport and have no sure what I should do. After searching online and on old posts on here, people suggest some steel wool and oil, but I couldn't find much on stainless steel barrels. Any suggestions? Any and all help is greatly appreciated! Thank you!
Reply With Quote
  #2  
Old 11-18-2015, 07:22 PM
Pathfinder76 Pathfinder76 is offline
 
Join Date: May 2007
Posts: 15,825
Default

Don't use steel wool on stainless steel.
__________________
“I love it when clients bring Berger bullets. It means I get to kill the bear.”

-Billy Molls
Reply With Quote
  #3  
Old 11-18-2015, 07:26 PM
Bushrat's Avatar
Bushrat Bushrat is offline
 
Join Date: May 2007
Posts: 6,914
Default

Try some toothpaste and a little water with a hard nylon tooth brush.
Reply With Quote
  #4  
Old 11-18-2015, 07:26 PM
catnthehat's Avatar
catnthehat catnthehat is offline
 
Join Date: Jun 2007
Location: Ft. McMurray
Posts: 38,567
Default

Quote:
Originally Posted by chuck View Post
Don't use steel wool on stainless steel.
X2!
Steel wool is detrimental to stainless, it can cause more rust than was first on the gun.
Kroil and and a cloth should take care of it, and a rub down with G96.
Cat
__________________
Anytime I figure I've got this long range thing figured out, I just strap into the sling and irons and remind myself that I don't!
Reply With Quote
  #5  
Old 11-18-2015, 07:30 PM
Bganz Bganz is offline
 
Join Date: Sep 2014
Posts: 121
Default

Quote:
Originally Posted by catnthehat View Post
X2!
Steel wool is detrimental to stainless, it can cause more rust than was first on the gun.
Kroil and and a cloth should take care of it, and a rub down with G96.
Cat
Ok thanks! No wool will come near this beauty!

Can you get Kroil at all the typical hunting/shooting stores?
Reply With Quote
  #6  
Old 11-18-2015, 07:31 PM
Hunter1602's Avatar
Hunter1602 Hunter1602 is offline
 
Join Date: Apr 2013
Location: Calgary
Posts: 1,629
Default

Use white vinegar and a light abrasive cloth pad.
Finish with a coat of gun oil.
Reply With Quote
  #7  
Old 11-18-2015, 07:32 PM
catnthehat's Avatar
catnthehat catnthehat is offline
 
Join Date: Jun 2007
Location: Ft. McMurray
Posts: 38,567
Default

Quote:
Originally Posted by Bganz View Post
Ok thanks! No wool will come near this beauty!

Can you get Kroil at all the typical hunting/shooting stores?
P&D sells it, but it is available at most industrial supply stores.
Cat
__________________
Anytime I figure I've got this long range thing figured out, I just strap into the sling and irons and remind myself that I don't!
Reply With Quote
  #8  
Old 11-20-2015, 05:42 AM
WbyHunter WbyHunter is offline
 
Join Date: Nov 2015
Posts: 49
Default

I wouldn't have even touched the rifle, or tried to clean it up. If you have pictures of what it looked like before you started cleaning it I would send them and the rifle back to where you bought it and see if they will go good for a new one.
Reply With Quote
  #9  
Old 11-20-2015, 09:18 AM
StenneS StenneS is offline
 
Join Date: Nov 2012
Location: Alberta
Posts: 56
Default

Let me know how you like that setup, I'm looking into something very similar if not the same.
Reply With Quote
Reply

Tags
cleaning, help?, rifle, rust, tikka

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 05:07 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.